Error messages

Driver Fault! Location No Longer Accurate

This means the machine is not turned on while it’s trying to move. Make sure the door & window are closed, the emergency stop is not pressed and the reset button has been pressed.

- - - + + + LIMIT SWITCH HIT ! +++ - - -

This means one of the input sensors is being activated when the machine is not expecting it. See **Sensors** for figuring out which “Input” is related to which sensor. ****Try to manually move the spindle away from whichever sensor it is by hand and try again.

User Arrow Keys to move Off of Prox Switch

This usually means that your Coordinate system is messed up, likely caused by moving the machine by hand when it was turned off. Move the spindle by hand inside the machine area, then Calibrate the machine in X and Y direction using C3 and try again

Troubleshooting

Machine doesn’t want to move when running a job

• Check if the door and window to the shopbot room are closed and if the reset button has been pressed. → Turning on machine
• Check if the emergency stop is in its release position
• Check if the machine is positioned outside of its cutting limits. (= too far to the left, right, front, back or up) If so, turn off the machine by opening the door and move the spindle back into the cutting area manually.

Machine doesn’t move when trying to move using keyboard